The 9 Things Your Parents Teach You About Kia Picanto Key Replacement

how to get a replacement key for a kia sorento to Fix a Dead Kia Picanto Key Fob

The Kia Picanto was built for the city. It zips through traffic voids that larger vehicles can’t, and navigates width limits as if they’re not even there. It is a compact car with a lot of features.

There are many reasons your Kia Picanto key fob might not be working. A dead battery is probably the most common cause.

Dead Coin Battery

The most common reason why a Kia Picanto key fob stops functioning is due to a dead battery. Usually the key fob will show warning signs prior to it dying or loses range or showing erratic behavior. It is recommended to replace your battery whenever you notice any of these symptoms before the battery is completely dead. Make sure to use a replacement battery that is the same voltage, size, and specification as your original one.

If the key fob still does not work, it might be an appropriate time to go to a dealer for a replacement. This is the only way to ensure the replacement will be correctly programmed and compatible with your car. If you attempt to program the key fob improperly, the internal chip can be damaged and cease to function.

A receiver module that has developed a fault is an additional possibility. This could be caused by a chip that has been damaged or weakened, or wear and wear and tear. It isn’t always easy to recognize the signs of this issue, however it’s important to investigate immediately. If you are unable to unlock your key fob, lock or unlock the doors, and even the spare isn’t working and you are unable to lock or unlock the doors, contact a dealership or service center to get help. They’ll be able determine the issue and fix it for you.

Faulty Chip

The key fob houses the chip that transmits a signal to a computer within the car. If the chip becomes damaged it will not transmit the correct code and the car’s immobilizer system will be activated. This could be due to various reasons. One reason is a low battery in the key fob. Water damage is another possibility. If the fob is wet, it’s likely that it will stop working.

A faulty chip can also be the cause of a Picanto key fob that isn’t turning on the engine. If you have replaced the battery and attempted to reprogramme the fob, but it isn’t working, it could be that the circuit board is damaged. You’ll need to replace the circuit board in this case.

Press the button on the back to release the fob. After this is done, you’ll be able take off the mechanical key. The video below will demonstrate how to replace the battery inside the key fob. Use a battery with the same dimensions and voltage. The Fob could be damaged if you use the wrong type battery. After replacing the battery, you should check it by pressing the lock button. If it works, you have a reliable Fob.

Faulty Receiver Module

The key fob you have is subjected to many abuses and isn’t indestructible. Over time, the buttons and battery contacts of your key fob may become damaged. It’s simple to repair it using a few tools.

The fob must transmit a message to a receiver in your car for it to work. If the module is inoperable, your fob will not be able to open or start your vehicle. There are many possible causes for this issue, but the first thing to do is reset the fob.

This is usually done by disconnecting the battery with 12 volts in the fob and letting it drain completely. Connect the positive and negative cables by reversed order.

If the battery is in good condition and the fob does not have any water damage, the issue could be due to the signal. This can be caused by various factors like interference from nearby transmitters or objects that operate on the same frequency band as your Picanto’s receiver.

Key fobs are sealed with rubber that stop the electronic chip from getting wet. However, if they are submerged in water, the chip could be destroyed. It’s crucial to keep your key fob free of water and only use key fobs that have waterproof designs.

Programming errors

Kia Picanto’s Key fob makes it easy to unlock and start your vehicle. You can also utilize the key fob to control your vehicle. It is essential to know how to utilize the key fob in a safe manner, especially when driving in adverse weather or when you have a limited mobility. There are plenty of Kia Picanto key fob tricks to help you out with this!

If your key fob stops functioning suddenly it could be due to an issue with its internal chip. It’s rare, but possible. It is best to visit an kia sorento key replacement dealer to pinpoint the issue.

You can also try to reset the Picanto keyfob. It’s a simple process that is done at home. The first step is to remove the key fob from the ignition switch. Connect the diagnostic tool under the dashboard to the OBDII connector and then start the engine. The diagnostic tool will be asking you for information regarding the Picanto. This includes the VIN number, make and model.

You can also examine the battery for a dead coin battery. The metal retaining clips that are inside the key fob are designed to hold the battery in place and complete the circuit. If the retaining clips are loose it could interrupt the flow of electricity causing an interruption in the function.